Re: Any tool and die makers here?

Posted by Rootsy on July 03, 2007 at 07:57:34 from (24.176.33.123):

In Reply to: Any tool and die makers here? posted by Bob Kerr on July 02, 2007 at 22:00:16:

Now I know exactly which part you are speaking of. Had them in my hand about a month ago when I put the live hydraulic back on my M and I replaced the input and pump shaft seals in the transmission.

Anyone know what the degree of draft is in the hole? Most wire EDM's can handle +/- 15 degrees (30 degree cone). Easy enough to probably do on the CNC lathe also... Both are right outside of my office door...

heat treatment required or those bolts will kill em as they are quite hard. Depending upon material and possible warpage in heat treatment they may have to be hard turned afterward...

Replies:

• Re: Any tool and die makers here? Bob Kerr 08:32:10 07/03/07 (0)

Add a Reply Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]