Re: Any tool and die makers here?

Posted by Sagebrusher on July 03, 2007 at 07:31:39 from (69.19.14.37):

In Reply to: Any tool and die makers here? posted by Bob Kerr on July 02, 2007 at 22:00:16:

Bob,

I am just now gettiing the input and pump shaft, clutch, front transmission seals and bearings on our 1950 M back together. (thanks ever so much to all who have shared their expertise on YT for shaft, seal, bearing and clutch removal in the last four or five years!) I am waiting for an output shaft transmission side coupler and drive "pawl" to arrive so I can complete the job.
Anyway, you are using the nomenclature that the current IH Case IPB uses. For my M the names and numbers are Clutch Joint Ring p/n 48967DA and they call the tapered bolts Clutch joint screw with nut and lockwasher p/n 48968DAX.
I think highly of Messick's, both their service and prices. They list the ring at 99.98 and the "Screw" assemblies at 22.46 with none currently in stock. Check and make sure that the H and M use common parts. My bolts had minimal wear but most of the the Retainers (rubber washers were questionable)
You might also try running a want add for the parts. I had good luck finding the used parts I needed on YT.
Good luck with your tractor, and thanks again to everyone Don

Replies:

• Re: Any tool and die makers here? Bob Kerr 07:49:54 07/03/07 (0)

Add a Reply Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]