Farmall & IHC Tractors Discussion Board |
Re: dropping the Liftall Pump
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Bob Kerr on July 02, 2007 at 21:00:03 from (205.188.116.73):
In Reply to: dropping the Liftall Pump posted by LinemanFarmer on July 02, 2007 at 05:03:58:
It really is as scary as it sounds, I had the one out of this parts tractor in 10 min total. The coupler was already taken off, but that only takes a few seconds to undo anyway. hardes part is getting the cotter pins out. Only 4 bolts hold it in, so watch out on the last one. While kneeling on the left side, I had the block of wood and the floor jack under it and ready to go. I took out the last bolt and steadied the pump with my right hand and used my left hand to work the jack to let it down. It would be easier if someone else steadied it or worked the jack, but the girlfiend was in "one of those moods". I got it ok.
Replies:
Home
| Forums
Today's Featured Article -
The Day Mom Drove the 8N - by Brian Browning. My Dad was wanting to put in a garden but couldn't operate the 8N and handle the old horse drawn plow he had found and rigged up to use with the tractor. Well, he decided to go get Mom out of the house and have her drive the tractor while he walked behind the plow. You got to understand that while my Mom is a hard worker who will always help whenever she can... she had never operated farm machinery before that day. Dad got her out there, explained how the clutch was the same as in our o
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|