Re: Farmall Super C - Spark Problem

Posted by El Toro on June 30, 2007 at 19:03:06 from (64.12.117.8):

In Reply to: Farmall Super C - Spark Problem posted by Dan(Mass) on June 30, 2007 at 17:14:10:

Did the engine run before you replaced all these items? You need to check for battery voltage at your coil. With the ignition switch on
you should have voltage on both small terminals on the coil with the points open.

If you have voltage there pull the coil wire from the distr. cap and hold it near a good ground then have someone snap those points open and close a few times to see if there's fire from the coil wire. You need to check to see if you have the plug wires in the correct firing order on the distributor and to the correct plug. Should be in this order: Hal

2-1
4-3 Since your rotor rotates CW.

Replies:

Add a Reply Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]