|
Farmall & IHC Tractors Discussion Board |
Re: Touch Control Rebuild, 100
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by georgeky on June 27, 2007 at 13:53:46 from (64.12.117.8):
In Reply to: Re: Touch Control Rebuild, 100 posted by mark on June 27, 2007 at 11:43:06:
Mark, I bought a 274 new in 82 and other than easy on fuel, I wouldn't trade a good Super A for two of them. It wouldn't start in 100 degree weather without heating it. A friend bought a 900 JD and it wasn't much better if any. I made a 3 point hitch for my M out of the one off the 274. I traded it to a new CaseIH 585 in 90 or 91, It wasn't any good either. It may have been alright, but would not run or pull with my 1980 584 IH. You are right about tobacco, it is hard to kill a weed. I don't see why foks need a 3 point on a SA. There are lots of SA implements in KY, I have several myself and no tractor to put them on.
Replies:
Home
| Forums
Today's Featured Article -
Engine Valves - Some Helpful Information - by Staff. Intake - On the intake stroke the piston moves doward, sucking in carburized fuel through the open intake valve. Exhaust valve is closed. Compression - With both the intake and exhaust valves closed, the pistons upward stroke compresses or squeezes the fuel into the combustion chamber. Firing - Ignited by the spark, the compressed fuel explodes and forces the piston downward on its power stroke. Intake and exhaust valves are closed. Exhaust valves and seats are exp
... [Read Article]
Latest Ad:
18-32 Case Cross Motor
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
