Farmall & IHC Tractors Discussion Board |
Re: HELP !! 300 UTILITY
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Wardner on February 17, 2007 at 18:41:31 from (4.154.244.242):
In Reply to: Re: HELP !! 300 UTILITY posted by tom nj on February 17, 2007 at 17:18:06:
I don't own a utility nor do I have the books. Perhaps utilities from that era weren't offered with IPTO. I dunno. I am looking at my Farmall 400 book. It is similar to your book as it shows Rockford and IH. They both use the same picture on separate pages. They both have the spline on the "PLATE, Back" item #8. I stand corrected and it's because I am used to looking at my M-SMTA book where the M backing plate has no splines. You need to go to the "power take-off drive" page to see the different hardware for old style PTO and IPTO. Item #4 (SHAFT, AND GEAR) plugs into the backing plate and it is where the IPTO begins. I doubt if that part is installed on your tractor
Replies:
Home
| Forums
Today's Featured Article -
Memories of an IH Super A When I was ? up to 10, I worked on my Papaw's farm in Greeneville, TN every summer. As I grew older (7), it was the thrill of my day to ride or drive on the tractor. My Papaw had a 1954 IH Super A that he bought to replace a Cub. My Papaw raised "baccer" (tobacco) and corn with the Super A, but the fondest memory was of the sawmill. He owned a small sawmill for sawing "baccer" sticks. The Super A was the powerplant. When I was old enough (7 or 8), I would get up early and be dressed to
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|