|
Farmall & IHC Tractors Discussion Board |
Re: What kind of forage harvester would fit a Farm
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Fromjb2 on February 15, 2007 at 18:08:13 from (74.101.67.211):
In Reply to: What kind of forage harvester would fit a Farmall posted by IH Man on February 15, 2007 at 11:24:44:
Hi my Dad, chopped many acres with a 300U in 2nd Lo T/A with an IH #15 forage harvester. Only thing was you had to fill the a gas tank every 4 or 5 hours as it only held 8 gals. Neighbour did try his H on the #15 harvester it ran it OK but did not have live PTO and no T/A. We later had a B414 and an IH #16 forage harvester and it would chop corn in 2nd gear. Someone else mentioned that corn plant population is a lot higher today than in the 1960s and requires either slower ground speed or more HP to chop corn silage. JimB
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
Measuring with Calipers - by Staff. The legs of inside calipers are curved outward at the extremities to facilitate measuring small holes, while outside caliper legs have a large curve inward to increase their capacity for large work. Firm-joint calipers are adjusted approximately by the hands and then set to the feel of the work by tapping them on a metal surface. It is a common practice when opening calipers by this means to tap the top of the joint. It is better, if possible, to tap the inside of the legs, as repeated blo
... [Read Article]
Latest Ad:
Late 50s early 60s international harvester 560 with cultivator
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|