|
Farmall & IHC Tractors Discussion Board |
Calling all F20 experts!
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Scott in SC on February 08, 2007 at 10:47:01 from (205.188.116.133):
I�ve got an F20 with a Heisler OD on it. I�ve drained then rear end lube out intending to change it; got about two gallons out, the book says it takes 8. I found the drain and filler plugs, but couldn�t find a plug to determine the correct level. Nebraska Cowman told me the plug is on the front of the tranny between the shafts. That means it is under the OD box. Can anyone give me an approximate measurement down from the top of the tranny to the bottom of the level hole? Is there another way to check of get the correct level? Perhaps measure down from the filler hole to the level? Be gentle, this is my first red tractor;)! Thanks much, Scott in SC
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
Product Review - by Staff. When we finally checked out the 3000 PSI North Star, the whole story chaned. This unit was equipped with an 11 HP Honda engine with fuel shutoff, adjustable flow and optional syphon degreaser dispenser. It didn't have a pressure release or electric start to facilitate easy starting but according to the instructions, simply pulling on the trigger while cranking was sufficient. This method of starting proved more than adequate and kept the cost down on the unit. It had all the important
... [Read Article]
Latest Ad:
1958 FORD RARE 4x4 801 TRACTOR, ELENCO/FRONT DRIVE, FRONTLOADER AND WEIGHTED REAR WHEELS, FIVE SPEED, LIVE PTO, GAS ENGINE, NEW REAR WHEELS AND TIRES, ENGINE RUNS.
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|