Re: Farmall U drawbar for M needed

Posted by RustyFarmall on February 07, 2007 at 05:26:44 from (199.120.81.197):

In Reply to: Re: Farmall U drawbar for M needed posted by Nat 2 on February 07, 2007 at 04:48:26:

Nat, I'll argue with you a little on the "dime a dozen". I've been to a lot of swap meets, looked at a bunch of M drawbar parts, including the U shaped piece, brackets, brace rods, swinging drawbars, rollers, etc. I have never found any of those parts that were any better than what I wanted to replace, and most were in far worse condition. I did run across a few that were in exxcellent condition, but priced higher than a new reproduction. I have a brand new swinging drawbar from Tisco, it's a dead ringer for an original.

Replies:

• Re: Farmall U drawbar for M needed John in Ct 14:10:59 02/07/07 (0)

Add a Reply Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]