Re: Ring Compressor

Posted by Roger Mills on February 03, 2007 at 06:27:53 from (71.213.68.25):

In Reply to: Ring Compressor posted by CNKS on February 02, 2007 at 12:45:29:

CNKS, hope you got 'em in by now but if not-try this; the compressor overlaps and won't go down into the bevel at the top of the sleeve, right? I went to home depot and got sheet metal duct that is not snapped together and then made a compressor that was 1/4" short of overlap by trimming the ends. I used a fine file to get rid of burrs. It is very thin and without the overlap it went far enough into the sleeve that the oil ring edge parts went in OK. I used a cut off piece of a broom handle to keep pressure on the top of the piston and gently tapped with a small hammer.

Replies:

Add a Reply Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]