Re: Water pumps how to

Posted by Roger Mills on January 25, 2007 at 11:54:34 from (71.213.68.25):

In Reply to: Water pumps how to posted by Roger Mills on January 25, 2007 at 08:31:10:

Thanks guys, I assume the A will not have any added problems from the B. What did you have to do to the gen bracket? Good idea Jim-perhaps one that will fit flush against the rad inlet? CNKS, ur probably right about junk in the block-I will be soaking it in soap and naval jelly solution and pressure flushing it as well. Some of the problem may be the thin sleeves. I think the engine was built up to be a puller-runs VERY strong, just too hot to last long. Also, no hint of bubbles in water so no compression leaks. Thanks again.

Replies:

• Re: Water pumps how to Janicholson 14:26:00 01/25/07 (0)

Add a Reply Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]