|
Farmall & IHC Tractors Discussion Board |
Re: 400 hydraulic pump
[ View Follow Ups ] [ Post Followup ] [ Return to Farmall & IHC Tractors Discussion Board ]
Posted by Ralph on February 05, 2000 at 17:16:25 from (209.180.73.8):
In Reply to: 400 hydraulic pump posted by Rod A. on February 05, 2000 at 13:25:29:
The first two posts are correct there are two steel lines with o ring between the block and pump. You may end up at a machine shop to have a block made with the desired fittings. Hope you got the plate with the timing cover. We have the block and steel lines as we took the pump off the 400 as it was giving trouble and needed a new pump and we didn't need it. Good luck. Ralph
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Farming Never Left My Blood - by Stan Gordon. I was born in 1947 youngest of ten of a working farm. Our farm was located in Saskatchewan near Saskatoon. We had a mixed farm consisting of grain and dairy all done with old machinery and by hand. My dad had a tractor, a Farmall A which was used mostly to run the thrashing machine, a seed drill and for plowing. I remember locals used to help each other and threshing was done from daylight to after dark, one farm to another until all farms were done.
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
