Re: sleeves on an A

Posted by El Toro on January 16, 2007 at 16:20:43 from (205.188.116.133):

In Reply to: sleeves on an A posted by Red A on January 16, 2007 at 15:55:12:

I used a piece of 2X2 oak and a hammer and drove them out. They're not pressed into the block.
Be sure to clean that block area where the new sleeve seals are installed. That area is where the dirt and rust collects. Clean the recessed
area at the top of the block where the sleeves seat too. Hal
PS: I used dish detergent on the lip of new sleeves so they would slide into the new seals easily.

Replies:

Add a Reply Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]