Farmall & IHC Tractors Discussion Board |
Re: How much does a Regular's engine weigh?
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by JohnG(TX) on January 12, 2007 at 12:29:32 from (216.136.20.34):
In Reply to: How much does a Regular's engine weigh? posted by Ludwig on January 12, 2007 at 06:38:27:
The complete engine is quite heavy. When I pulled the engine out of my F-20 and Regular, I tried to make it as light as possible. I used an old chain hoist suspended by a steel pipe in the rafters of the pole barn. I removed the head (about 100+lbs) and the flywheel(about another 75lbs). Once you get it on the ground, you can remove the bell housing (about 65lbs) to get it small enough to work with. The actual bare block is only around 150lbs, but add in the crankshaft and it goes up fast. I pulled the flywheel on my Regular while the engine was still in the frame. That made the flywheel easier to get out.
Replies:
Home
| Forums
Today's Featured Article -
A Farmall Story - by Ed Meadors. The year was 1978. Our young family had recently moved to rural Chesapeake, Virginia to a plot of land which would finally allow us to realize our dreams of a huge garden, critters and more lawn and pasture than we would ever use! We needed a TRACTOR; not a riding mower or tractor wannabe, but a real TRACTOR. The answer to our needs materialized in the form of a '44 Farmall A, complete with cultivators, discs, single plow, a 5ft.Woods belly mower and one, mounted spare 9.00x24 rear wheel.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|