|
Farmall & IHC Tractors Discussion Board |
HyTran/Mystik Compatability
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Michael Sheik on January 09, 2007 at 08:26:31 from (199.153.205.246):
I run HyTran in my 1066. I purchased a Hesston 1014+2 HydraSwing swather last weekend that I will use behind the 1066. The previous owner said he runs Mystik Universal Trans/Hydraulic fluid in his Ford tractor that he used with the swather. My oil is brand new in the 1066 and do not want to do anything to jeopardize it. Can I hook up to the swather and use realizing there is some mystik in the cylinders and lines on that swather. Probably 2 or 3 gallon estimated. I could drain the hyd. lines but I do not think I can get everything out of the cylinders. One other question: The side to side swing on the swather has a double acting cylinder(two hoses) but the wheel raise/lower are single acting cylinders thus only one hose on this. Is there a specific port on my 1066 remote coupler on the back that I plug in the single hose or am I going to have to add on something.
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
Measuring with Calipers - by Staff. The legs of inside calipers are curved outward at the extremities to facilitate measuring small holes, while outside caliper legs have a large curve inward to increase their capacity for large work. Firm-joint calipers are adjusted approximately by the hands and then set to the feel of the work by tapping them on a metal surface. It is a common practice when opening calipers by this means to tap the top of the joint. It is better, if possible, to tap the inside of the legs, as repeated blo
... [Read Article]
Latest Ad:
Late 50s early 60s international harvester 560 with cultivator
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|