|
Farmall & IHC Tractors Discussion Board |
I need Mag help!!
[ View Follow Ups ] [ Post Followup ] [ Return to Farmall & IHC Tractors Discussion Board ]
Posted by p on February 04, 2000 at 09:33:40 from (209.186.155.115):
I was replacing the points, condensor in my Super A mag and was distracted by my buddies who stopped by and I took off the cover to the gears that reduce the rate of spin and reverse the rotation. When I took off the cover out came the gear with the cover. it was already too late by the time I realized what I did, How do I accurately re-time the rotor. I tried going to top dead center #1 until the mag snapped and adjusting the rotor to point at #1 spot on the cap but I do not feel that is very accurate since one tooth off makes a big difference. I could not find timing marks but did not look very hard. This motor was stuck and so I expect a very hard start and would like to eliminate the timing from the equation. P.S. this is the SA that some of you have helped me get this far, so thanks for any more help!!!
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Horsepower Defined - by Staff. Indicated Horsepower This represents the power developed in the enine cylinder as obtained from the pressure in the cylinders. This is pressure obtained from an indicator which shows cylinder pressures. Indicated horsepower does not represent the actual useful power delivered by the engine. Brake Horsepower This is the actual horse power delivered by the engine to the shaft. It is equal to the "indicated horsepower" less the friction of the engine. It is useful hor
... [Read Article]
Latest Ad:
Late 50s early 60s international harvester 560 with cultivator
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
