|
Farmall & IHC Tractors Discussion Board |
Re: I Give Up
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by JayWalt on January 02, 2007 at 08:07:22 from (24.223.138.48):
In Reply to: Re: I Give Up posted by teddy52food on January 02, 2007 at 06:22:22:
The 3rd brush is fixed. T^here is no way to move it at all. I've had the generator completely apart. It is fixed. One of the other poster, has reaffirmed this. "Jay, I read with some interest your post and the replies. IHC evidently produced several different versions of 6-Volt charging systems, since I have a Super-A with the exact system you describe - a 'fixed' (according to the manuel) 3rd brush generator with a 4-terminal regulator (Arm terminal on the back; F, Bat, and Load terminals on the side) and a 3-position light switch. My regulator (Delco-Remy) was rubber-mounted, so it had an additional ground strap connected from the regulator base to one of the mounting bolts on the tractor (I recently had to 'farmerize' a new mount, since the rubber had disintegrated)." From Gene-AL I just looked at my manual, and it IS a fixed 3rd brush generator.
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
It Can't Be Done! - A Tractor Story - by Neil Campbell. I'll never forget the time back when I was a boy baling hay on our Farm in Big Rapid, Michigan. The most memorable event that took place was a trip up the steepest incline on the farm pulling an old New-Idea baler with a pony-motor for power and a haywagon. I had just talked my Dad into buying an old John Deere B with 6-speeds ahead and I was real proud of it, except it was a little smaller than the Case tractor that we normally
... [Read Article]
Latest Ad:
Late 50s early 60s international harvester 560 with cultivator
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|