Farmall & IHC Tractors Discussion Board |
Re: H/ Rotella Oil?
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Randy as in Randy-IA on December 24, 2006 at 08:38:17 from (207.177.83.116):
In Reply to: H/ Rotella Oil? posted by Tom Windsor on December 23, 2006 at 20:45:39:
I got my M 15 months ago in sept. and took the pan off and cleaned out leaves and twigs and globs of sludge and other unknown stuff , removed and cleaned a mostly plugged oil pickup and filled it with Rottella T 15-40 . I think the tractor was had just recently been pulled out of a grove and started and then sold ( I bought it off ebay ) . I pulled my hay equipment this summer with it and when I changed oil not to long ago the oil looked good and so did the filter . The problem I have is the bearings in the transmission are growling . But the engine runs good and it also pulled a 30 foot spike harrow over freash tilled ground with spikes straight down in fourth gear ( whatever that means ) I really don't know how hard a spike harrow pulls , I usually pulled it behind the 1755 Oliver so I didn't even know it was there . Just my 2 cents , but I wouldn't worry about it . Merry Christmas ! ...Randy
Replies:
Home
| Forums
Today's Featured Article -
Ford Part Number Trivia - by Forum Participants. "Replaced by" means the part was superseded. All of my part books date back to 1964 and New Holland have changed some part numbers. They usually put the old Ford part number on the package. I was suppressed when I looked up the part number of the auxiliary drive shaft because for some reason the part number went through a radical change and it lost its "Basic Part Number". Ford part numbers follow the following rules. Most part numbers are in three parts. The middle part is called the
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|