Farmall & IHC Tractors Discussion Board |
Re: Super C versus 140
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Hugh MacKay on December 22, 2006 at 14:08:35 from (64.228.11.78):
In Reply to: Re: Super C versus 140 posted by Carp on December 22, 2006 at 06:30:20:
Carp: You bring out a good point here. In all the years my dad and I farmed we never gave serious consideration to C, SC, 200, 230, etc. Just too much tractor for that little engine. The H, SH, 300 and 350 were just as manuverable, thus one may as well have engine enough to handle 36" or 38" tires. I've seen my brothers 230 get enough traction on tilled soil to kill the engine in low gear. A 130 or 140 will spin out in low gear before running out of power. If your going to have a small engine you may as well have a small tractor. Any of the offsets are at least 2' shorter, very convenient in close quarters. Back in the 50s we ran a 7' semi-mount mower, would bolt up to either 130 or 300. The 130 would mow hay faster than 300. They are also very nice on a rake. Even when I was round baling hay in the 70s, 130 and SA still did the raking, now it took two rakes and those two tractors to keep up with the pace set by the round baler. You know something, one hell of a bunch of 8, 10 and 12 year old kids raked that hay and learned to do something useful with a tractor. Dad was the hay rake teacher, they had to do it right, he took the time to make sure they did. I've seen him taking the time too show some very young, never saw any diapers but it was close. Most of dad's students are now in their mid 40s, and some of the best drivers around. Those little tractors always had a place on a multi-tractor farm.
Replies:
Home
| Forums
Today's Featured Article -
The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
18-32 Case Cross Motor
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|