|
Farmall & IHC Tractors Discussion Board |
Re: farmall m lift all question
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Mike Schwartz on December 22, 2006 at 01:24:09 from (65.162.174.144):
In Reply to: farmall m lift all question posted by Mike Schwartz on December 20, 2006 at 23:04:22:
Jakee, do the cylinders on your '43 H mount under the front of the engine and run back towards the steering wheel at about a 45 degree angle? If I raise the loader some and add more oil it will go all the way up but when I lower it back down it pukes the extra oil back out. P.O. had a extra tank cobbled on but everything leaked so trying to clean up some. Would like to see a pic of your loader if you have one? Jed, thanks for the info, Mike S.
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
50 Tips for Ford N Owners - by Bruce Haynes. Over the years of owning these three tractors, I have managed to refresh what little mechanical knowledge I had and add a little more, thanks to the wisdom and helpfulness of many fellow N owners. So, now it's my turn to share a few of the tips I've picked up.
... [Read Article]
Latest Ad:
Massey Ferguson model 65 diesel tractor
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|