Farmall & IHC Tractors Discussion Board |
Re: 400 starting issues
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by karl f on December 20, 2006 at 20:06:01 from (209.23.173.44):
In Reply to: Re: 400 starting issues posted by GordoSD on December 20, 2006 at 14:33:19:
one time a few years back, something didnt shut off right (likely the needle valve/float)and the entire intake and combustion chambers were filled with gas. so mentioning the carb has merit. it only happened 2 times, and never again. there is a lot of varnish coating on the outside of the carb near alot of the gasket or screw seams. have to consider workin on that one day then! tractor was supposed to be thouroghly overhailed around 1990, dont think we've got 100 hours on it yet! -karl
Replies:
Home
| Forums
Today's Featured Article -
Updatin The Charging System of Your Older Tractor - by Tyler Woods. Older tractors have externally regulated generators or externally regulated alternators, in some instances. That means there is one device that turns energy from the fan belt into electrical energy,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|