Farmall Tractors Discussion Board |
Re: Pressed Vs. Cast Steel Wheels
[ View Follow Ups ] [ Post Followup ] [ Return to Farmall Tractors Discussion Board ]
Posted by Jim Becker on February 02, 2000 at 17:58:18 from (209.30.173.20):
In Reply to: Pressed Vs. Cast Steel Wheels posted by Larry(SD) on February 01, 2000 at 12:55:48:
You can be sure that (particularly as labor costs went up) either one was cheaper than spoke wheels. I think you will find the cast wheels used on nearly any tractor that adjusts the track by sliding on the axle, or where there is no adjustment. You start counting parts and it probably comes up cheaper. The stamped disks have a big offset so track can be changed by reversing it (Yes, I know some cast wheels have an offset.). For small tractors and utility models the long axle would be a real nuisance for most usage. The lighter stamped wheel is a lot easier to handle when adjusting track. And yes, the A (most) through 140 had a heavy wheel on the right side to partly offset the engine weight. It added about 70 or 80 pounds.
Follow Ups:
Home
| Forums
Today's Featured Article -
Show Coverage: Godfrey, Illinois Country Days - by Cindy Ladage. Except for last fourth of July's Old Gold show in Springfield, Illinois, I don't remember when it was so hot. Nevertheless, the heat didn't keep vendors and visitors alike from enjoying the third annual Country Day's Event. Jane Elliott said the event was originally a one man show. "Barry Seiler, owner of Country Town Farm Supply store used to invite people up to the Johne Deere store. He would give hats and a free meal for everyone that brings a tractor." Elliott said while this
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|