|
Farmall & IHC Tractors Discussion Board |
Re: LEAKING CUB CARB
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by dan hill on December 13, 2006 at 03:49:19 from (64.12.116.65):
In Reply to: Re: LEAKING CUB CARB posted by SuperA-Tx on December 11, 2006 at 17:45:05:
Dirt in the needle and seat is the cause of most carb leaks.In any case the fuel must be shut off when the tractor is idle.A hole in the float is a common cause of rough running.I bought a 77 chev pickup from a fellow who complained about poor gas milage.I found the plastic carb float had absorbed gas, the vacuum advance didnt work and the auto choke pull off only opened the choke part way.The truck was easy on gas if you kept it under 50 mph.Replacing the 4 bbl carb would have cost plenty, new float cost 5.00.
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
Measuring with Calipers - by Staff. The legs of inside calipers are curved outward at the extremities to facilitate measuring small holes, while outside caliper legs have a large curve inward to increase their capacity for large work. Firm-joint calipers are adjusted approximately by the hands and then set to the feel of the work by tapping them on a metal surface. It is a common practice when opening calipers by this means to tap the top of the joint. It is better, if possible, to tap the inside of the legs, as repeated blo
... [Read Article]
Latest Ad:
Late 50s early 60s international harvester 560 with cultivator
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|