Re: Rings for H

Posted by GordoSD on December 11, 2006 at 06:15:03 from (66.115.200.140):

In Reply to: Rings for H posted by Tom Windsor on December 10, 2006 at 19:29:03:

Pull the piston and the rings. Remove the rings from piston. Keep them sorted same side up as when installed. Put one ring at a time back in the sleeve, and use a feeler gauge to check the end gap. Tolerances are in your manual. Chances are high they will be WAY out of tolerance.
NOw put the piston back in, without the rings on it. Check the gap between the piston and the sleeve. If it's within tolerances just replace the rings.
It's pretty inexpensive to just put in new sleeve, piston and rings. Just check and see if you are standard (2 3/4) or oversize.

Gordo

Replies:

Add a Reply Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]