|
Farmall & IHC Tractors Discussion Board |
Can't get my M started?
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by unioncreek on November 27, 2006 at 19:20:35 from (64.126.155.156):
My M hasn't been running right since I put the mag gears back in, thought I had them right. So I put the #1 cylinder at TDC and the rotor was off a little, so I turned the gear one cog. It ran great while I adjusted the carb. Pulled it outside and left it idle and it quit after about 3 minutes. It would start but would only run less than a minute. Pulled the carb off to check and make sure nothing was in it, checked the sediment bowl and their both clean. The flow of gas is good at the hose and out of the drain in the carb. When I can get it started it will run for a little bit and then want to die I can nurse it along with the choke, but it will eventually quit in less than a minute. Any help or suggestions is appreciated. Bobg
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
The David Brown Rose Badge - by Samuel Kennedy. In the 13th century civil war was raging in England. Two English noblemen were involved in a conflict which became known as the War of the Roses. The Duke of York had as his emblem a white rose and the Earl of Lancaster had a red rose. Today the white rose is the official emblem of the county of Yorkshire and the red rose has been adopted by the neighboring county of Lancashire.
... [Read Article]
Latest Ad:
1965 International Harvester McCormick Farmall cub tractor 2,500. Two owner tractor. My grandfather bought new in 1966, then we inherited it. Have all the paperwork original manual and all maintenance records. It starts and moves. Comes with underbelly mower, plough, and some other attachments.
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
