Farmall & IHC Tractors Discussion Board |
Re: Dirty Oil
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Tom Windsor on November 26, 2006 at 17:37:05 from (64.12.116.65):
In Reply to: Dirty Oil posted by James Newton on November 26, 2006 at 16:23:03:
I had this bright idea once with a S-10 pickup truck. I decided to clean the engine out. I drained it and put high detergent oil in there and took off to the NC mountains. About half way there, it just quit running. (I had not been looking at the gages...I was off floating around in outer space) The Engine would not turn over...locked up. Well, I pulled the pan. The pickup for the oil pump was COMPLETELY clogged with sludge and it could not pick up the oil and starved it. The result is, I have been snake bit with this cleaning stuff. If I even thought about doing it any more, I think I would pull the valve covers and the pan and steam clean everything and then blow it out with air and still not be happy with it. TW
Replies:
Home
| Forums
Today's Featured Article -
Ford Part Number Trivia - by Forum Participants. "Replaced by" means the part was superseded. All of my part books date back to 1964 and New Holland have changed some part numbers. They usually put the old Ford part number on the package. I was suppressed when I looked up the part number of the auxiliary drive shaft because for some reason the part number went through a radical change and it lost its "Basic Part Number". Ford part numbers follow the following rules. Most part numbers are in three parts. The middle part is called the
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|