|
Farmall & IHC Tractors Discussion Board |
Re: junk tires
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by moseed on November 25, 2006 at 09:40:24 from (207.177.239.36):
In Reply to: junk tires posted by Bill Geer on November 24, 2006 at 10:09:24:
Out here (California) we are as restricted as it gets I think. For throw aways I take a sharp knife and cut through the side walls about two or three inches from the bead all around the tire on both sides. Cut the tire in four equal pieces and the land fill will take them for no extra charge. If they are small worn tractor tires a sharp linoleum knife works well, if large tires I use a knife to cut the side walls and a sawzall to cut the four equal pieces. If on the rim cut through the bead (wire and all)once (after you have removed the tread portion) to get them off the rim and the land fill takes them that way, no charge. I use a 6" grinder with a stone wheel to cut the bead. If you have a sharp knife it takes almost less time to do the deed than to tell it. Have fun!!!
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
Maintaining Rubber Tires - by Staff. The broad use of rubber tires on farm tractors and machinery has resulted in a great saving in both time and operating costs since the time of steel wheels. There are, however, certain basic fundamentals in the care of tires that should be followed carefully if the owner is to derive maximum benefit from his or her investment. First and most important is to maintain proper pressure for the work at hand. Your best guide to proper inflation is the operator's manual or instruction book tha
... [Read Article]
Latest Ad:
2555 Mahindra Shuttle 4x4 heat,air,diesel,7ft Mahindra heavy duty bushhog 7ft snowblade bucket
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|