|
Farmall & IHC Tractors Discussion Board |
Re: Farmall Hubs
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by migraine on November 22, 2006 at 09:03:33 from (71.231.54.158):
In Reply to: Re: Farmall Hubs posted by John A. on November 21, 2006 at 20:06:31:
The Massey hubs are interchangeable with the M Farmall but too big for the H. I believe that the only two hubs that work on an H are the MM Z model and the Oliver 77, but the key will have to be milled down a bit to fit in the axle slot and the MM Z hubs are not real heavy but will work fine under 5000 lbs. Correct me if I am wrong. There may be a few 8 bolt hubs off later IH utility models that would work and then use an 8 hole to 9 hole adapter. Just a thought. Migraine
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
Pop's Tractor of Gold - by Gary Teate. My father was a simple man but could repair just about anythin mechanical that was ever made. From the time I was a young boy growing up in Jacksonville, Florida, I would spend a considerable amount of time helping my father repair or rebuild equipment and engines, etc. on our 2 1/2 acre "spread". Pop always dreamed of having more acreage out in the country where he could retire and tinker as much as he wanted and often reminisced about his boyhood days on his grandfathers farm in Montecello,
... [Read Article]
Latest Ad:
1952John Deere MT tractor
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
