Re: Int'l 966 Hydro Will Not Move

Posted by Allan In NE on November 22, 2006 at 06:08:43 from (148.78.243.26):

In Reply to: Re: Int'l 966 Hydro Will Not Move posted by Marvin on November 22, 2006 at 03:43:16:

Marvin,

It almost sounds as though a valve is "dumping" until that higher pressure hits it.

I'm assuming you've done the simple things like the filter, checking the foot-n-inch valve adjustment, the control lever adjustment, etc.?

Does the tractor lug okay when it does "act right", or is it weak in the knees? Is this problem in both forward and reverse or just forward?

Have you tried unhooking those two little bleed lines and blocking 'em off at the transmission to see if it will operate normally just using the mechanical lever?

That would eliminate all hydraulic controls upwards of the transmission and tell you where the problem lies; be it either upstairs in the control valve bank or down in the transmission itself.

Allan

Replies:

• Re: Int'l 966 Hydro Will Not Move Marvin 17:36:47 11/22/06 (0)
• Re: Int'l 966 Hydro Will Not Move Allan In NE 06:22:47 11/22/06 (0)

Add a Reply Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]