|
Farmall & IHC Tractors Discussion Board |
H cam gear and mice
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Andy Sommer on November 22, 2006 at 05:57:36 from (165.139.177.249):
I finally seperated my block from the bell housing last night around 11:00. Found a bunch of mice nest in and around the bell housingand throw out bearing. Good news is the pressure plate, clutch, and fly wheel look pretty good. ..... My questions are these, do I need a gear puller to remove the cam gear off the front of the block. With everything removed, I cannot turn the crank over. I did bang on number two piston a little and got the gear to move enough to reach one of the bolts behind it, however, someone told me to just just pull the gear, however, I am not sure.... Also, the pistons are froze pretty good. Found that hidden bolt behind the starter to free up the block, that was a tricky one. I always remember my dad saying, if is stuck, there must be a reason it is stuck.
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
Bad Vibes - by Curtis Von Fange. One of the strangest ways to communicate with our tractor is to ask it how it feels. "Ask it how it feels," you say? Yup, ask it how it feels. Now, as with the other articles in this series one has to be able to hear what 'ole blue' is trying to say in response. The nice thing about our old iron friends is that they are usually quite consistent in their response, rather unlike some people I know who might change what they say due to the weather or other mitigating circumstances. But since t
... [Read Article]
Latest Ad:
1965 International Harvester McCormick Farmall cub tractor 2,500. Two owner tractor. My grandfather bought new in 1966, then we inherited it. Have all the paperwork original manual and all maintenance records. It starts and moves. Comes with underbelly mower, plough, and some other attachments.
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
