Farmall & IHC Tractors Discussion Board |
Lift All Oil Seal removal
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by AH64Dattack on November 20, 2006 at 13:02:01 from (140.153.203.4):
Ok my friends I have changed the Oil Seals on my 47 H's drive shaft and the counter shaft to the life all. I have the lift all on the floor and the reservoir separated from the pump with the drive nut removed. The seal looks to be intact but thought I should replace it sense I have it out. Not sure if it was leaking or just wet from the transmission side. Is there a good technique to remove the seal other then cutting it out from the front? Thanks, Ron
Replies:
Home
| Forums
Today's Featured Article -
Magic Moments - by Tyler J. Woods. Magic moments don’t just happen. You have to help them along. This morning, I got up early. It is my day off from my regular workweek and I had a lot of things to do. It’s fall, and with winter coming on, there is a lot of work to do before weather closes in.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|