|
Farmall & IHC Tractors Discussion Board |
Re: Implements for use with a Super H
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by CNKS on November 19, 2006 at 19:14:10 from (204.249.178.135):
In Reply to: Implements for use with a Super H posted by RSCO on November 19, 2006 at 17:34:16:
I can't really give you the size of the land plane, as it depends on how deep you run it. In the 50's my dad rented one from Soil Conservation Service (current name is Natural Resource Conservation Service or something like that). We pulled it behind an H, but it was also used by people with much larger tractors. I think it was about 8 feet wide or so. I assume the "roller" harrow you mention is a disk harrow. If it is a 4 gang tandem disk, probably 8 feet if you weight it good, maybe 10 with no weight, assuming it is the old drag type. Wheel controlled ones are heavier, maybe 8 feet if you try to run it deep. If it is a rotary hoe with a low power requirement, probably considerably wider, maybe 15 feet, only a guess.
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
My Ford Golden Jubilee - by Troy Estes. This article is about my '53 Ford Jubilee and a story that starts with taking the tractor to my brother's Starter/Alternator Rebuilding shop for a wiring fix. The generator was shot as well as all the wiring. I dropped off the tractor expecting a transformation from a 6 volt to a 12 volt system utilizing the original generator housing, and a total rewiring of the whole tractor. The front end center pin bushing was worn also so I ask that they replace it if they had time. Well, that�s wha
... [Read Article]
Latest Ad:
1965 International Harvester McCormick Farmall cub tractor 2,500. Two owner tractor. My grandfather bought new in 1966, then we inherited it. Have all the paperwork original manual and all maintenance records. It starts and moves. Comes with underbelly mower, plough, and some other attachments.
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|