Re: H drawbar

Posted by Janicholson on November 18, 2006 at 16:49:15 from (66.173.50.118):

In Reply to: H drawbar posted by Steve Dencklau on November 18, 2006 at 16:32:09:

Measure the hole (I think it is an inch and an eighth, but do not believe that #. Then purchase a grade 8 bolt with a shank that size and long enough to have only shank used to do the task. Cut the bolt (abrasive cutoff, or several hacksaw blades) and put it in. It is held in place with a rectangle of 3/16 strap measuring about one inch by 1-1/2 " with a 3/8 course thread bolt holding it in (I think that is the size, check it before screwing in the wrong threads) JimN

Replies:

Add a Reply Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]