Re: Farmall B crank pulley

Posted by K-Mo on November 12, 2006 at 13:51:24 from (65.169.189.2):

In Reply to: Farmall B crank pulley posted by Bob Frey on November 12, 2006 at 12:39:49:

The way I do it---
1. Make sure the surfaces are clean and smooth.
2. You should find a threaded hole in the end of the crankshaft. Utilitze this hole,a piece of allthread, washers and a nut to pull the pulley onto the crackshaft.
3. I warm the pulley in the oven. Warm, but not too hot to handle.
4. Line it up and pull it on.

The close fit is all that holds it on.

Replies:

Add a Reply Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]