Re: cam shaft gear

Posted by Jon Aller on October 25, 2006 at 05:42:57 from (155.109.5.21):

In Reply to: cam shaft gear posted by daniel gillespie on October 25, 2006 at 04:47:05:

Can you weld? I made a simple puller with a 4 inch long section of pipe that was just smaller than the diameter of the center of the 3 holes of the cam gear. I welded 3 small L shaped pieces that lined up with the hole locations on one end and a strap with a nut welded to it on the other end. Just put the L shaped peices in the holes and turn to engage the back of the gear. Screw a rounded bolt through the nut and pull the gear right off. It took me ~ 45 minutes to make it from scraps.

Replies:

Add a Reply Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]