Farmall & IHC Tractors Discussion Board |
Re: Farmall H Rgulator
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by John T on October 19, 2006 at 06:51:04 from (66.244.90.5):
In Reply to: Farmall H Rgulator posted by w400 on October 18, 2006 at 22:21:00:
Eric, it will still work fine if you feed lights off the ammeters load terminal (which is how it works on 3 wire VR systems that dont have the extra 4th VR LOAD terminal), which is the same terminal that wires down to the BAT terminal on the Voltage Regulator, orrrrrrrrrr if you rewired them fed from the VR's LOAD terminal...... Its just that the 4 wire VR system can provide a tad better regulation and operation plus the load current doesnt have to pass through the VR's Cutout Relay as it does if fed from the ammeter or the VR's BAT terminal (same point electrically). If the tractor was originally equipped with a 4 wire VR versus the old 2 wire cutout relay system, it would have had 2 wires down to the VR from the dash already anyway, one being from the ammeters load side terminal to BAT on the VR and the other from the light switch to the VR's L terminal. If it was the 2 wire cutout relay system with only one wire from the ammeter (or only a 3 wire VR with NO L terminal) down to the genny and relay area, then you would need to run the extra wire from the light switch to the L terminal........ If it were mine and for no more work n expense thats required (almost nuttin) I would rewire the lights to be fed from the VR's L terminal since you have a 4 wire VR Its your tractor and your choice and it still works either way, but I believe a bit better (although you may never notice or realize much if any difference) if you utilize the L terminal. Thats my story n Ima stickin to it lol John T
Replies:
Home
| Forums
Today's Featured Article -
History of the Nuffield Tractor - by Anthony West. The Nuffield tractor story started in early 1945. The British government still reeling from the effects of the war on the economy, approached the Nuffield organization to see if they would design and build an "ALL NEW" British built wheeled tractor, suitable for both British and world farming.
... [Read Article]
Latest Ad:
18-32 Case Cross Motor
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|