|
Farmall & IHC Tractors Discussion Board |
F20 road gear, ATTN: f20inmi, Nebraska Cowman
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by IndianaMike on October 18, 2006 at 20:48:45 from (71.98.68.209):
So I got the unit from the guy yesterday and as luck would have it, the shifter fork was frozen. So I soaked in tranny fluid (on the kitchen table no less) and the fluid went everywhere. Pounded the shift fork out and found out why it was stuck; shaft bent. Wondering if either the Cowman or f20inmi were willing to part with the fork, which is just a shaft with a u-shape one end and threaded on the other. The shaft is 1/2 inch diameter and about 6 or 7 inches long. I don't know whether I can bend it back straight enough to work or not. Also, the input yoke would be nice as well, since it didn't come with one. Just shoot me an email and we'll discuss it. Thanks, Michael
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
Product Review: JB Weld - by Staff. JB Weld is basically an epoxy glue that does an exceptionally good job of bonding to cast iron and steel along with several other materials. As I mentioned, it is so common that I have yet to buy a tractor that did not have JB Weld used somewhere. It is sometimes used so well you can't tell its there and other times used as a sloppy quick fix. Finding where and how it can be used correctly is key to whether you are using it as an "inelegant hack" or an integral solution to difficult and expens
... [Read Article]
Latest Ad:
65 Massey FERGUSON DIESEL
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|