|
Farmall & IHC Tractors Discussion Board |
Re: Parts manual look-up for 450 or 560 tractor
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Wardner on October 18, 2006 at 18:21:35 from (4.154.241.159):
In Reply to: Parts manual look-up for 450 or 560 tractor posted by Charlie on October 18, 2006 at 17:23:54:
Your part number is item 47 in my 560 book page 166. It appears your problem is there are two item 47s. It depends on which shaft you have. The other "RING, clutch retainer snap" is 373 588 R1. It goes with "Shaft" 373 546 R1. SHAFT # 373 546 R2 uses RING # 376 821 R1 It looks to me like one shaft and ring were made obsolete. I think you have to buy the shaft that goes with the ring you bought. Sorry about that. I can't scan but I will try to photograph the page and send it to you.
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1965 International Harvester McCormick Farmall cub tractor 2,500. Two owner tractor. My grandfather bought new in 1966, then we inherited it. Have all the paperwork original manual and all maintenance records. It starts and moves. Comes with underbelly mower, plough, and some other attachments.
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
