|
Farmall & IHC Tractors Discussion Board |
Adjusting TA
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by mulcher on October 18, 2006 at 17:42:25 from (63.163.138.206):
Did the adjusting of the TA on my 1586 after reading old posts on here and reading the IT manual for my 1086. Got the snap ring set down snug and added a half turn. When the plunger comes up and there is suppose to be 1 1/8" I only have 7/8". Is that OK? Had trouble setting the dump valve also like the book says. Have it now so lite goes off just before clutch engages. Also set free play and trans brake.
The 1086 will almost lift the front wheels off the ground when you shift to direct but the 1586 is lot slower shift and smoother and made me wonder which is right?
Enjoy reading all the posts. Brian
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
Major Problems - by Anthony West. Following the aquisition of the two Fordsons to my collection I found that I was struggling to move them about. I had considered the possibility of driving the "F" to and from shows but anything other than local rallies was totaly impractical due to its sedate pace. I had also considered buying a landrover and trailer, but the price of a
... [Read Article]
Latest Ad:
1965 International Harvester McCormick Farmall cub tractor 2,500. Two owner tractor. My grandfather bought new in 1966, then we inherited it. Have all the paperwork original manual and all maintenance records. It starts and moves. Comes with underbelly mower, plough, and some other attachments.
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
