Farmall & IHC Tractors Discussion Board |
Re: M Trans Coupling Help
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by terryjd98 on September 24, 2006 at 15:18:08 from (69.159.82.153):
In Reply to: Re: M Trans Coupling Help posted by Nebraska Cowman on September 24, 2006 at 11:28:46:
Thanks Cowman that pic looks like the way I remember it looked like when I took it apart. I do think by the looks of it the shaft is not all the way in. Right now that coupler will just fit inbetween the 2 shafts. Looks like there should be all kinds of room for the coupler to fit up in there. Thought there was when it came apart. I only worked 10 hours on it yesterday the other 10 split up between Thursday and today so had a bit of a break. I did walk away a few times but came back to the same problem. I hate to give up on something till its done, guess need to learn to take a longer break. Thanks again Terry
Replies:
Home
| Forums
Today's Featured Article -
Tractor Traction - by Chris Pratt. Our first bout with traction problems came when cultivatin with our Massey-Harris Pony. Up till then, this tractor had been running a corn grinder and pulling a trailer. It had new unfilled rear tires and no wheel weights. The garden was already sprouting when we hooked up the mid-mount shovel cultivators to the Pony. The seed bed was soft enough that the rear end would spin and slowly work its way to the downhill side of the gardens slight incline. From this, we learned our lesson sinc
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|