Farmall & IHC Tractors Discussion Board |
Re: 26ft Vibrashank 45
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Hobbyfarmer71 on September 15, 2006 at 11:01:35 from (68.20.140.7):
In Reply to: 26ft Vibrashank 45 posted by MichaelNEIowa on September 15, 2006 at 08:26:16:
Micheal That 806 will pull the 26 footer all day long, just don't put it in the ground. :) Here is a thought, buy the 26 footer, and take off the wings until you upgrade to bigger tractors and equipment. The main base is still what 14-16 foot wide... the 806 will pull that nicely. If you don't upgrade the tractor you can always use the wings as spare parts........ Just a thought.
Replies:
Home
| Forums
Today's Featured Article -
The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
18-32 Case Cross Motor
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|