Re: M 12 volt conversion

Posted by Bob on September 02, 2006 at 12:09:38 from (66.163.134.211):

In Reply to: Re: M 12 volt conversion posted by Tom(the old guy) on September 02, 2006 at 11:43:18:

Let's try this again...

Wire to starter switch (battery side) ALONE on one side of ammeter. JUST THE ONE WIRE ON THAT POST.

Wire from alternator, and ALL electrical loads to the other post of the ammeter.

Then, you need to watch the battery VOLTAGE.

If it is over 15.5 Volts, you have a regulator problem.

If it is low (less than 14.5 Volts, or so), and the alternator is still charging heavily, it points to a bad battery (shorted cell).

Also, you say "it goes to full charge"... is that on an original 15-0-15 or 20-0-20 Amp ammeter, or a replacement 60-0-60 Amp ammeter?

Replies:

• Re: M 12 volt conversion Tom ( the old guy) 13:08:43 09/02/06 (0)

Add a Reply Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]