Re: IH #1300 sickle mower

Posted by Janicholson on August 30, 2006 at 10:30:01 from (199.17.6.122):

In Reply to: IH #1300 sickle mower posted by Dan Robertson on August 30, 2006 at 04:47:23:

Welding the business end will break again as noted below. Welding an extension to the tip will work because there is only a tiny fraction of the force applied to it there. It might take some thinking and machining to accomodate the extension, but it would not need to be as hard a material. Many of the bars are tapered from mount to divider board, so the mount and taper might be important. Good luck, JimN

Replies:

Add a Reply Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]