|
Farmall & IHC Tractors Discussion Board |
Re: Super A parts
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Pa. Pete on August 29, 2006 at 14:38:02 from (204.97.243.153):
In Reply to: Re: Super A parts posted by Jack in OH on August 29, 2006 at 12:20:53:
Jack, I use a 5' KingKutter that I drag behind, attached to my drawbar, using the rear PTO with an over-riding clutch. Couple of things- First, the KingKutter is EXTREMELY heavy. I'm not all that strong- I can lift the tongue if I put my legs into it, but I then can't pull it forward onto the drawbar if it's on turf, so I just jack it up and back the SA into it. My father-in-law has a 5' bushhog, (sorry, don't know the make) and I can lift that sucker with one hand and I bet I could pull it up a flight of stairs. He's offered to let me try pulling his MUCH lighter one, but I haven't tried it yet. So theres a big difference among makes. That said, I'd have to say that the SA is a little light, (at least right now. See below) and here's why. I do fine on gently sloped ground, but I have a side to my fields that tail-off toward some woods, where it gets close to 15-20 degrees, and she labors there. (Going uphill. She cuts fine going downhill. LOL) I take the PTO out of gear there, and just cut going downhill. ALso, going steep uphill I can feel the steering getting real light too, which aint a good feeling. The other wrinkle is that I'm in this godforsaken crop reserve program that's supposed to clean up the Cheasapeake. It's a 10 year contract thing, and I can only cut 1/4 of my land every year, so after 3 years unchecked growth, I'm mowing through some pretty tenacious thick stuff, including this woody spiky tangle of vine that hugs the ground. It'll grab your boot and trip you if you try to walk through it. With a full cut, the SA will tend to bog down in that, so each pass I only make a partial cut, and I do fine. When I helped my father-in-law cut his field, with only a one-year growth, I had no problem at all with the SA, even with slopes. So it depends on what you're cutting. I'll be curious to see what its like trying his lighter bushhog. Can't do it now. I got tire problems. LOL I'm sorry I got in that crop program. I got every weed known to man, and some that ain't known even to God, and they keep reseeding themselves. It gets so dang thick, I cant see the groundhog holes coming. It's a mess.
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
Product Review - by Staff. When we finally checked out the 3000 PSI North Star, the whole story chaned. This unit was equipped with an 11 HP Honda engine with fuel shutoff, adjustable flow and optional syphon degreaser dispenser. It didn't have a pressure release or electric start to facilitate easy starting but according to the instructions, simply pulling on the trigger while cranking was sufficient. This method of starting proved more than adequate and kept the cost down on the unit. It had all the important
... [Read Article]
Latest Ad:
1958 FORD RARE 4x4 801 TRACTOR, ELENCO/FRONT DRIVE, FRONTLOADER AND WEIGHTED REAR WHEELS, FIVE SPEED, LIVE PTO, GAS ENGINE, NEW REAR WHEELS AND TIRES, ENGINE RUNS.
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|