Farmall & IHC Tractors Discussion Board |
Re: 460/560 manifold
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by migraine on August 27, 2006 at 19:28:49 from (71.231.54.158):
In Reply to: Re: 460/560 manifold posted by Rockytop560 on August 27, 2006 at 18:10:55:
The manifolds from the 221, 263,291,and 301 gas motors should all be interchangable. This is basically the same block with just different sroke and bore. I bought two aftermarket manifolds a few years back but had to put a slight angle in the upright pipe to use the existing hole in the hood on the 560,s. they have held up well with no problems but if you can find an original that would be great. Most of the tractoras that come in the salvage yards here have big holes in them or cracked beyond repair. Tractor models that you are looking for are 460,560,656,706 and 666 gas models. Hope this helps. Migraine
Replies:
Home
| Forums
Today's Featured Article -
George's Fordson Major - by Anthony West (UK). This is a bit of a technical info to add on to the article about George's Major in the "A Towny Goes Plowing" article. George bought his Major from a an implement sale about 18 years ago for £200.00. There is no known history regarding its origins or what service it had done, but the following work was undertaken by Harold alone to bring it up to show standard. From the engine number, it was found that the major was produced late 19
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|