|
Farmall & IHC Tractors Discussion Board |
SEAL NUMBERS OF TRANNY AND BELLY PUMP
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Ted form Maine on August 23, 2006 at 14:38:03 from (205.188.116.133):
I just lowered the belly pump on my H. Never repaired anything in this area before. I was wondering if any one can tell me the NAPA seal numbers for the following:
The seal number for the shaft the comes from the engine and goes into the tranny (need seal number for the seal at the tranny).
The seal number for the shaft that comes out of the tranny and drivers the belly pump. And the seal number where the shaft comes out of the engine (if there is one, besides the engine
main seal.And is there a seal inside where the input shaft goes through the belly pump housing. Thanks in advance for your most appreicated assistance.
Replies:
Home
| Forums
Today's Featured Article -
Tractor Traction - by Chris Pratt. Our first bout with traction problems came when cultivatin with our Massey-Harris Pony. Up till then, this tractor had been running a corn grinder and pulling a trailer. It had new unfilled rear tires and no wheel weights. The garden was already sprouting when we hooked up the mid-mount shovel cultivators to the Pony. The seed bed was soft enough that the rear end would spin and slowly work its way to the downhill side of the gardens slight incline. From this, we learned our lesson sinc
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
