Farmall & IHC Tractors Discussion Board |
Re: Trailer to haul Farmalls
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Turbos10 on August 23, 2006 at 04:08:51 from (76.0.78.86):
In Reply to: Trailer to haul Farmalls posted by OT on August 22, 2006 at 11:20:36:
Well, the goose neck is nice if you have a large enough truck to pull it or you need to pull two at a time. I use an 18' car hauler for my M with no problems. You can reverse the wheel centers and move them in far enough to load it without hitting the ramp. They look better like that IMO anyhow. My trailer has standard 3500lb axles, so load is limited. If I were you I would get one with 5000lb axles. I would also suggest hide away ramps and steel floor while you are at it. Just my .02
Replies:
Home
| Forums
Today's Featured Article -
The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
18-32 Case Cross Motor
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|