Farmall & IHC Tractors Discussion Board |
Re: Trailer to haul Farmalls
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Harley on August 22, 2006 at 16:51:25 from (64.12.116.65):
In Reply to: Re: Trailer to haul Farmalls posted by RustyFarmall on August 22, 2006 at 14:35:42:
Na, the bank won't touch it. They said I would have to get a low interest minority SBA loan to fill it. There's two a them big old 186 gallon jobs on there. I got the far one turned off as 50.00 worth of diesel fuel wouldn't even get the bottoms of both tanks above the suction pipe. And if ya sat on a slope sideways very long, it would even drain the uphill tank into the lower one. Harley
Replies:
Home
| Forums
Today's Featured Article -
The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
18-32 Case Cross Motor
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|