Farmall & IHC Tractors Discussion Board |
Re: HEY GUYS CHECK THIS OUT THOUGHT ON STUCK MOTOR
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Fancy Farm on August 20, 2006 at 20:29:01 from (208.145.0.106):
In Reply to: HEY GUYS CHECK THIS OUT THOUGHT ON STUCK MOTOR posted by magman on August 20, 2006 at 04:58:59:
Remove head stuck valves make the job harder. soak with your choice of oil I use trans fluid and wd 40, after 2 weeks put a hyd bottle jack under crank on stuck cyl chain down the tractor and jack up on crank always worked for me never tore anything up yet and the last one I did had been sitting in a barn with the hed off for several years. replaced sleeves put in new rings and all is well.
Replies:
Home
| Forums
Today's Featured Article -
The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
18-32 Case Cross Motor
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|