|
Farmall & IHC Tractors Discussion Board |
Re: Splitting a farmall H (need help)
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by RustyFarmall on August 19, 2006 at 14:36:28 from (207.32.13.230):
In Reply to: Splitting a farmall H (need help) posted by James.01 on August 19, 2006 at 14:02:14:
No need to split the tractor just yet, split the piston instead. Start by drilling some holes into the top of the piston. The holes need to be close to the outside edge of the piston, but not right at the edge. Once you get a large enough hole, then insert a hack saw blade down through the hole and begin cutting your way over to the edge. It will be a slow process. You need to cut all the way through the skirt of the piston, but be careful to NOT cut into the sleeve, or at least do not go through the sleeve. You may find it necessary to make a second cut in order to take a "wedge" out of the piston. The piston rings will be next to impossible to cut through, so you might need to do a little gentle "breaking" of things, but do be careful that you don't attempt to pry against the cylinder wall as you can easily break a hole into the wall, and then you will have scrap iron.
Replies:
Home
| Forums
| Order Support
Today's Featured Article -
Harry Ferguson - The Man & The Machine Harry Ferguson was christened Henry George but every one called him Harry. Harry was born in a small Irish town called Growell in County Down about 16 miles from Belfast. Harry Ferguson led a varied and colorful childhood causing mischief where ever he could. He showed mechanical aptitude at a very early stage in life and showed no inclination towards
... [Read Article]
Latest Ad:
Late 50s early 60s international harvester 560 with cultivator
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
